The upgraded sE Electronics sE-T2 is a large condenser microphone with a titanium-sputtered dual-diaphragm capsule. This microphone will revolutionise your approach to engineering and production. With a wide frequency range of 20Hz to 20kHz the sE-T2 will capture every last nuance of any performance. The sE-T2s high-frequency response is incredibly natural. Rest assured knowing your performances will not sound excessively bright. The microphone is the ideal choice for recording kick drums pianos pop vocalists as well as amplifiers. Youll find that due to its balanced low and mid frequencies the sE-T2 responds well to any form of EQ. Featuring a brand new die-cast all metal housing and a reinforced spring steel wire mesh grille. This update provides the microphone with ultimate durability whilst in use. Further improvements include a polished finish and an upgraded shock mount.
Loud and clear One of the perks of using a solid-state microphone is its lightning-fast response to transients. Youll be able to capture loud percussive sounds without the fear of saturation or loss of detail. This is down to the sE-T2s titanium capsule. Stronger than any gold spluttered capsule the T2 stands its ground against instruments with high SPLs. Place it right in front of any source knowing its performance will be nothing short of excellent. Reworked and refined sE have remodelled the T2 with a brand new die-cast all metal housing and a reinforced spring steel mesh grille that both protect the capsule and give the whole microphone a sturdy and robust build. A new polished finish gives the microphone a clean and professional aesthetic. sE have gone to lengths to improve the shockmount as well. It is designed to be as low profile as possible and not get in the way of equipment. The shockmount is designed to assist the angling of the microphone it minimises the risk of low-end rumble ruining your recordings and allows you to get near to any source. Youll be able to record up close without compromise. Features Upgraded version with a polished die-cast body robust spring steel mesh grille and improved shockmount Titanium capsule captures the punch and impact of percussive sources Controls to dial the mic into your application 4 polar patterns: cardioid supercardioid omni and figure-8 2 pre-attenuation pads 2 highpass filters Frequency Response: 20Hz-20KHz Requires +48V phantom power Includes flight case Specifications Frequency Response: 20Hz-20KHz Sensitivity: 28mv/pa-31 ± 1dB Polar Pattern: Omni Cardioid supercardioid Figure 8 Impedance: ≤ 50 Ohms Equivalent Noise Level: 14dB(A weighted) Max SPL for 0.5 THD@1000Hz for 0.5 : 140dB minimum Power Requirement: Phantom power 48V±4V Connector: 3-pin Dimensions and weight: Microphone: 5.8 x 2.9 x 14.6 cm ( L x W x H ) 0.29kgShock Mount: 0.22kgFlight Case: 30.3 x 19 x 13.3 cm ( L x W x H ) 1.415kgProduct Code: SE-T2-2022
CHECK PRICES AT ZZOUNDS
