Reamping made simple. The Radial ProRMP Studio Reamper is a 100% passive Reamper and does not require any external powering.
The magic behind the ProRMPs great tone is a custom wound transformer that converts the balanced line level source to a hi-z output for your amp whilst acting as an electrical isolator- eliminating troublesome ground loops that can often cause buzz and hum in the sound.
Extremely easy to use the ProRMP connects from the recorder to your amp and effects units performing all required impedance matching for you. Just adjust the level to suit! The ProRMP is built tough encased in 14 gauge steel housing with a I-beam frame that protects all internal circuitry from damage. A full-bottom no-slip pad provides plenty of stay put while also electrically isolating further reducing any unwanted noise caused by ground caused by ground loops.
Specifications
Audio circuit type: Passive transformer isolated
Frequency response: 20Hz 20KHz (+0/-1dB)
Dynamic range: >137db
Equilavent input noise: >-98dbu
Noise plus gain Phase deviation: 0.3° @ 100Hz; 5° @ 20Hz
Gain: >-10db
Maximum input: >+26dbu
Total harmonic distortion: 0.003
Common mode rejection ratio: 100dB @ 60Hz (unbalanced source)
Input impedance: 600 Ohms
Output impedance: 600 Ohms balanced
Noise: -111dbu
Signal to noise ratio: 81db
Input pad: -15dB
180° polarity reverse: Inverts signal polarity
Ground lift: Disconnects pin-1 at XLR output
Merge: Input summing mixer
Speaker filter: -30dB pad and band-pass filter
XLR configuration: AES standard (pin-2 hot)
Power: Passive no power required
Construction: 14 gauge steel chassis and outer shell baked enamel finish
Size: 3.3″ x 5.0″ x 2″ (84 x 127 x 48mm)
Weight: 1.55 lbs (720 g)