Signal transmission made simple. The Radial Catapult Mini TX and RX Bundle allows you to send and receive four channels of analog mic or line-level audio through a standard shielded Cat 5 or Cat 6 Ethernet cable. This removes the need for messy cable runs and bulky multi-channel audio snakes. Just clean and safe signal transfer in a compact and lightweight package.
The four XLR connectors on each module are connected via straight wire to the RJ45 socket, ensuring that your audio passes through without having to worry about coloration or distortion. No digital audio conversion is needed, ensuring that your signal maintains its original quality with no signal loss, noise, or interference. And with Radial’s legendary build quality, the Catapult Mini TX and Mini RX modules are sure to provide you with years of reliable routing.
The Radial Catapult Mini system gives you a highly effective and intuitive solution without sacrificing audio quality. Equipped with four XLR connectors that are wired directly to an RJ45 connector, the Catapult Mini TX allows you to send four channels of balanced audio to your Catapult Mini RX via a single standard shielded Cat 5 Ethernet cable. This has many benefits. The most obvious is that it dramatically reduces complicated cable runs, keeping your venue or workspace tidy and safe. There’s no need for bulky multi-channel audio snakes anymore.
The Catapult Mini system lets you transmit your audio over long distances while maintaining the original quality of your audio signal. This can be used for both mic and line level signals, giving you outstanding versatility when it comes to routing your gear.
Features:
– Compact passive audio snakes that enable you to send and receive four channels of analog audio over standard Cat 5 or Cat 6 Ethernet cable
– Receiver with male XLR connectors for connecting to your mixer interface or recorder
– Transmitter with female XLR connectors for connecting to either mic or line level sound sources
– RJ45 input connector for hooking up standard Cat 5 or Cat 6 Ethernet cable
– Allows you to send and receive mic or line level signals from distant locations without signal loss, noise, or interference
– No digital audio conversion is needed, your high-quality analog signal is maintained throughout the signal chain
– Allows you to utilize standard shielded Cat 5 Ethernet cable, which is widely available, lightweight, and economical
– Easy to connect the two Catapult modules, which then use analog conductors in the cable to deliver four balanced audio lines to any destination
– Enables you to make use of pre-existing cable installations that are pre-wired for Cat 5
– Perfect for transmitting audio between distant rooms without the need to install or supply new cabling
– Removes the need for bulky and expensive multi-channel audio cable, allowing contractors to benefit from pre-installed network cables for connecting rooms
– Passive design requires no power to operate and doesn’t require any signal conversion
– Straight-wire connections from the XLR connectors to the RJ45 connector ensure audio passes through without coloration or distortion
Specifications:
– Audio Circuit Type: Passive splitter
– Frequency Response: 7Hz – 20kHz
– Dynamic Range: 140dB
– Total Harmonic Distortion: 0.0005% at 1kHz
– Common Mode Rejection Ratio: Greater than 103dB
– Maximum Input: +35dBu
– Input Connector: Male XLR
– Output Connector: RJ45
– Construction: 16-gauge steel chassis and outer shell
– Power: Passive, no power required
– Dimensions: 105mm x 40mm x 33mm (L x W x D) (each)
– Weight: 0.4kg (each)
– Product Code: CATAPULT MINI RX-TX
