Signal transmission made easy.
The Radial Catapult Mini RX 4-Channel Receiver allows you to receive four channels of analog mic or line level audio through a standard shielded Cat 5 or Cat 6 Ethernet cable. This removes the need for messy cable runs and bulky multi-channel audio snakes. The Catapult ensures clean and safe signal transfer in a compact and lightweight package.
The four male XLR connectors are connected via straight wire to the RJ45 socket ensuring that your audio passes through without having to worry about colouration or distortion. No digital audio conversion is needed your signal will maintain full integrity with no noise or interference. Thanks to Radials renowned build quality the Catapult Mini RX is sure to provide you with years of reliable routing.
Features:
– Compact passive audio snake that enables you to receive four channels of analog audio over standard Cat 5 or Cat 6 Ethernet cable
– Equipped with male XLR connectors for connecting to your mixer interface or recorder
– RJ45 input connector for hooking up standard Cat 5 or Cat 6 Ethernet cable running from your transmitter
– Allows you to receive mic or line level signals from distant locations without signal loss noise or interference
– No digital audio conversion is needed your high-quality analogue signal is maintained throughout the signal chain
– Allows you to utilise standard shielded Cat 5 Ethernet cable which is widely available lightweight and economical
– Easy to connect two Catapult modules which then use analog conductors in the cable to deliver four balanced audio lines to any destination
– Enables you to make use of pre-existing cable installations that are pre-wired for Cat 5
– Perfect for transmitting audio between distant rooms without the need to install or supply new cabling
– Removes the need for bulky and expensive multi-channel audio cable allowing contractors to benefit from pre-installed network cables for connecting rooms
– Passive design required no power to operate and doesnt require any signal conversion
– Straight-wire connections from the XLR connectors to the RJ45 connector ensures audio passes through without colouration or distortion
Specifications:
– Audio Circuit Type: Passive splitter
– Frequency Response: 7Hz – 20kHz
– Dynamic Range: 140dB
– Total Harmonic Distortion: 0.0005-percent at 1kHz
– Common Mode Rejection Ratio: >103dB
– Maximum Input: +35dBu
– Input Connector: Male XLR
– Output Connector: RJ45
– Pin Assignments: RJ45 Pin 1: XLR CH 4 Pin 2 RJ45 Pin 2: XLR CH 4 Pin 3 RJ45 Pin 3: XLR CH 3 Pin 2 RJ45 Pin 4: XLR CH 2 Pin 2 RJ45 Pin 5: XLR CH 2 Pin 3 RJ45 Pin 6: XLR CH 3 Pin 3 RJ45 Pin 7: XLR CH 1 Pin 2 RJ45 Pin 8: XLR CH 1 Pin 3
– Construction: 16-gauge steel chassis and outer shell
– Power: Passive no power required
– Dimensions: 105mm x 40mm x 33mm / 4.125 x 1.56 x 1.31 (L x W x D)
– Weight: 0.4kg / 0.85lbs
– Warranty: Radial 3-year transferable
Connectivity:
– Controls and Indicators
– Male XLR Outputs: For connecting to the inputs of a mixer or recording interface
– RJ45 Input: Receives analog audio over Cat 5 or Cat 6 Ethernet cable
Product Code: R800-8029-00
CHECK PRICES AT ZZOUNDS
