Great monitoring starts here. The Neumann MA 1 Monitor Alignment takes the difficulty out of room correction. With an individually calibrated measurement microphone and user-friendly software its like having an expert engineer right in the room. The best possible sound for home studios and professional control rooms. The MA 1 Monitor Alignment software automatically calibrates your stereo monitors. Advanced calibration algorithms make it easy to get world class results no matter where you mix master and monitor. No special drivers. No additional plug-ins. All alignment data is stored directly into your DSP-powered monitors. Adjust phase and amplitude with the software. You dont need special acoustic knowledge to get great results. This kit does the hard work for you.
What’s in the box 1 x MA 1 Microphone 1 x Microphone clamp 1 x Quick guide 1 x Safety guide Software is downloadable FeaturesExceptional acoustic results for stereo home and professional studio setups Highest accuracy for tonality and impulse reproduction Purpose built for stereo pairs of Neumann studio monitors Correct your room with ease thanks to advanced calibration algorithms Developed by the world’s leading institute for audio signal processing (IIS) for the best monitor quality possible Easy to use software compatible with both Mac and PC No plug-in or special audio drivers required – everything is stored in the DSP-powered monitors for ease of use Optimised amplitude response and phase thanks to dedicated software Comes fully equipped with an individually calibrated measurement microphone Specifications Acoustical operating principle: Pressure transducer Directional pattern: Omnidirectional Frequency range: 20Hz – 20kHz Sensitivity at 1kHz into 1 kohm: 30 mV/Pa -30dBv +/- 3dB uncalibrated | 30 mV/Pa -30dBv +/- 0.5dB calibrated (via software) Rated impedance: 50 ohms Rated load impedance: 1000 ohms Equivalent noise level CCIR: 39dB Equivalent noise level A-weighted: 27 Db-A Maximum SPL for THD 0.5 : 132dB Signal-to-noise ratio CCIR (re. 94 dB SPL): 55dB Signal-to-noise ratio A-weighted (re. 94 dB SPL): 67 dB Maximum output voltage: 10dBu Supply voltage (P48 IEC 61938): 48V +/- 4V Current consumption (P48 IEC 61938): 3 mA Matching connector: XLR3F Weight: 37g Diameter: 23mm Length: 117mm Please note: The software requires Windows 10 64 Bit and ASIO driver or macOS 10.13/10.14/10.15 or 11.0.
CHECK PRICES AT ZZOUNDS
